bNc's latest activity
-
BThe check valve is likely intended as backup to the bay manifold check valve to keep high pressure from backing up the line to the...
-
BThat's a check that your pointing to. Where does that hose go back to that's is connected to the check valve?
-
B" The black rubber plunger seat should be slightly recessed. If it is swollen you can try to shave it flat with a sharp single edged...
-
BYes, that parker mini regulator will work. It's about the only one I use. Again, I've never seen a filter/regulator used on the liquid...
-
Ba lot of times on the coleman stands the regulator goes out and restricts flows to the solenoid manifold. Also make sure your check...
-
BGreg is right there is no way you need a dual Flo-jet pump in that application. A single Flo-jet pump will be more than adequate in your...
-
BGreg is correct take apart your liquid solenoids I promise you they need rebuilding or replacing as well as the regulator. Make sure the...
-
BAre you diluting that product with water before mixing it in the hydrominder? It is an ultraconcentrate. Plus it will have virtually...
-
BIm not familiar with the pumps you have there. You also dont have pictured your pre-soak manifold but assuming its the same as your...
