I am looking at maybe updating my price sign at my inbay automatic. I am looking into the possibility of adding a LED screen.
I could then add video of :
1. Current prices like shown but also
Short video clips or animations showing
A. how to enter bay so tire is on trundle
B. which way...
Turns out the sensor at the exit side had gotten damaged. From the track getting ground down. It was sending a bad signal. Again appreciate all your help as I learn how to diagnose this thing;)
How do you check the Pulse Counter? My problem has come back. It almost always fails on the last pass with the dryer. Once it completed but then travelled half way down the track and thought it was in its home position and ready for the next car.
Thanks for your replies. Just to close the loop in case anyone else has this issue.
The problem was the worn track. when the gantry moved to the home position it would then drift back about an inch and a half because the track was worn and made a slope. Grinded down the track and that appears...
New error code for me. GAH-S3 F020 Limit Switch input Exit Travel Limit.
I have had a good run of no errors but now this one has come up. happens about every other car so can't really leave the wash open.
Maybe unrelated but during one cycle. The power washers went on and off several time at...
Which type/model door do you have. I ask because I had a similar issue with my Airlift XRS Door. It was a door issue not the carwash. Signal was going to door but door did not react. Turned out a bad relay switch in the Door Control box was the issue.
Honest question. Are there any impacts to the environment from graphene. I know the impacts of soaps and other chemicals but my quick search was not very informative. Curios if any dealers or operators have any insight..
Thanks for everyone's input.
Cleaned the wheel and the bar that it sets on. adjusted one prox switch ever so slightly to get it closer to the metal sensor. Then Tightened the bolts that keep the orange wheel pressed down onto the bar, that took a little wiggle out of the brush.
So after 60...
Good Afternoon. My Vii Choice wash has started to error out when soft touch is chosen. I am getting the same error.
SB1...F016 Limit switch input not on SB retracted Limit
This happens when the brushes are at the back of the car. I believe it relates to the drivers side, side brush. I do have...
I have an in-bay automatic. Owned for 5 months now. We close at 0 F. Prior owner said it was too difficult to keep bay warm and initial spay would frost windows making it difficult for drivers to drive on tire sensor.
Side note. We had a blizzard last Friday. winds blew a panel out of...
I have the following error code on my washtech: 016 End position not reached Limit switch, outside
It errors out when the brushes are at the back of the car.
Still learning about this system. Is this something as simple as a switch replacement or is it more involved and should call for...
Wanted to update the group for future people. It ended up being the Rotary Acuator. Service person replaced. It was not quite as easy to replace as I would have thought. He had to apply a little heat to it to get the couple off.
I did follow the airlines and could see they were all good and so...
Wondering if anyone can point me in the right direction or how to trouble shoot. The Horizontal bar that holds nozzels for both soaps and spray off. At the front of the car it will rotate from pointing straight down to horizontal to get the front of the car. but at the back of the car. It never...