Search results

Thank you, we will try to clean it out first and then go from there.

Thanks again. Looking at the 555 it hooks to the high pressure side horizontally to the pump, and the black hose (water coming in) that is going to the unloader now goes to the inlet side of the 555 and my white hose, water coming out, of the top of the unloader goes to the outlet side of the...

Thank you! When swapping from the unloader to a regulator is the hook up the same? It looks like I have a hose coming in to the back side of the unloader and one on top. Looking at the 555 regulator pic it looks like only one connection for hose.

I am troubleshooting a drop in pressure on a 5cp2102W Cat Pump. Without the trigger pulled the PSI is 1500 and drops to 700 when pulled. I have checked the valves and just rebuilt the head. I have also replaced the nozzle tip in the bay. From what I have read...if that did not solve it it may be...

Earl, Where can I find the Blue Bill acceptor $1 $5 $10 stickers?

Thanks!

Randy...Ill check it again, but I think it is right where the black boom hose meets the 90. Just bubbles a little there. Probably just needs tightening, but was curious what the 90 was just in case. I do have swivels at the brush end of the hose...never thought to put at the boom end. Do you...

Sorry...should have explained better. It is a new LP hose and swivel. It is leaking where the black boom hose meets the "elbow". Wondering what the "elbow" connection is and where to find it? I may just need to tighten it, but just in case was wondering what it was.

I have a slow leak where the foam brush hose connects to the low pressure boom hose. Not sure what the connection is called or where to find it.

Good idea. I can definitely sand and polish them out. I could not find the red lenses on the GinSan site. Can you send a link?

Thank you! I will try that. Would you happen to have a part # for the Lexan covers?

Dan, Yeah it is an old set up. I was just hoping GinSan had a display that I could put in that spot since it was cut into the brick to house it.

I am needing to replace my old GinSan 31 Display Timers. They are too dim and some are not showing the numbers fully. Currently have GS-401 Timers in the pump room. What model would fit in the bays to replace the GS31s?

Ended up replacing the rotary switch. All good for now.

Scott, This is an old post, but wondering what the fix was? I am having the same issue now in one bay. LP works...HP doesn't. I got it running for a few days by tightening the connections in the meter box. Then stopped working again. I am thinking it is the rotary switch.

Thank you for the detailed response. Ill try all of that.

So to start, the wax was not getting to the bays. It was backflowing back into the drum. We changed the hydro minder and it did it again, wasting two total drums of wax. Then we checked the flow from the bottom of the tank and it started drawing from the drum to the tank properly. The problem...

Thanks for the help...it was the timer

Thank you. I was thinking about replacing the timer but thought I would at least ask the question first. Thanks for the quick response.

I have 2 older JE Adams 3 motor super vacuums one door (cannot find model #, the sticker is to old). Both of them are suddenly requiring 20 plus quarters to start, what can be the problem? Both currently have a Ginsan GS-403 Timer.