Search results

Call Istobal parts department @ 800-336-8795 ext# 112 and ask to speak with Michael. They have both decals in stock. part# SIG1296 full door decal part# SIG1290 touchpad overlay How’s that @Greg Pack?😂

Worked at Magic Wand several years. Where is this wash located?

Email sent

I have the electrical schematic for the M7, if you would like that, pm me your email address.

Have you confirmed that 11 and 21 are jumped together on the switch? According to your video, only the high pressure functions are working. My question is, when you turn it to high pressure soap and the pump kicks on, does it spray soap or just water? Same thing with high pressure wax, does it...

If the bay is set for 8 coins and comes on with 5, it’s either the timer or coin mechanism. You can test that following the info in the attached photo. As far as the the functions working on the rotary switch , as long as 11 and 21 are still jumped together, you got a bad switch.

Can you tell us a little more about ruining a Nayax reader with 26.5 VAC? Did the display just go dead or did it quit sending pulses? Just curious, because after reading your post I looked at the specs of the Nayax reader and seen where the recommended incoming voltage was 12-24 VAC or 12-42...

According to the Rowe manual, the out of service light is 12vdc

Just installed the Yolink device and hub that @Greg Pack linked in this thread, to email me when a customers automatic goes out of service. Works perfectly!

Just ordered the Yolink device Greg linked and a hub. Looking forward to installing it.

Of those 2, Slugbuster

What would that solution be?

Never heard of them. Where are they located?

[QUOTE="soonermajic I can't find anywhere to buy the Istobal awesome Tire Shine equipment... Maybe Istobal?

I've personally never used 3/8" check valves, but I can't see them making any noticeable flow difference. Especially being mounted right above the boom.

Glad you got your issue resolved and back to working properly. Also, thanks for reporting back to everyone, (especially those who commented with advice on what to check) on what you did to fix your problem.

Randy, you would be correct. Old Magic Wand self serve bench. I would definately buy the valve you referenced instead of the Asco one. Only reason he would need the valve at all, is if he is using hot water for soap and wax. If it is cold water in the gravity feed reservoir tank for soap and...

Are you running hot water for soap and wax that pulls from the stainless steel holding tank? If the answer is no, you don't even need that 1/2" Asco Valve. Brass 2-Way N.O. Solenoid, 1/2” NPT, 125PSI, 24VAC|ASCO|8210G034 (kleen-ritecorp.com)

Turn air off to the pump and unhook the discharge side of the flow jet. Start adding air back to the pump and see if it's pumping.

I'm guessing the issue or the fix is top secret.