Search results

I was having a problem with soap and wax pressure checked out check valve and i felt it was working, after reading these post i pulled out check valve and put in a swing check which was all i had handy, pressure work perfectly Thank to all

We are back in the game changed a few parts and finally replaced the option board and we are working again thanks to all and Brian LandON

I had to let it go for a while it was driving me crazy I checked just to maake sure , it's not in test mode alan

Sorry I don't

used mark v11 try this site :)http://www.landonscarwash.com/contact.htm

mark v11 scr We opened the plc and couldn't see any burn or corrosion, smacked the 24 relays and put it back to gether and could you beleve it worked. at least for now and maybe for a lot longer Thanks for your help Alan

testing I will test today by the tapping method and then open plc unit. Its not working now so i have nothing to loose. I let you know what i find Thanks Alan

I was wondering if maybe you can help me. I have a scr dated 1992. Here is my current problem, I got to wash on sat and machine was up again't front door. It must have kept going past the limit switch on the track. I check the sensor for the limit and it does send a signal to the plc...

i signed up in ny and i am now in kazakhstan and can use to call all my us phone numbers no charge alan

Thank You alan

has anybody tried these for winter door in self serve strips are 8 0r 12 inches wide any info would be nice

i check out site and will call the in am i think it bothers me more than it does customers thank you alan

could you tell us part number sounds like would work for us alan

air shamme we installed unit in attic from roof joists works great bought 3 motors from kleen-rite mounted on plywood use 24 volt relays from KR uses 1 1/2 rubber drainage tees to 2 " hose to diskin boom and gun also their by pass alan installed at least a year ago

This the second time we lost a 3hp 3phase motor of ss unit during power failure. Seems that one leg of electtric company line was down and some one came to use wash. they called when it wouldnt work and when we arrived the work room was full of smoke. 1st time i fought with elec co, they said...

jerry here what i did and it worked in testing cut piece of 3/4 inch pve pipe put in hole where reciept come out, laying flat. then took a piece of alum flashing and bent 1/4 inch hem to hold it and slide it into the door where the reciept falls down making sure that in between the door and the...

jerry thats exacty the problem iam having i maybe cutting bigger hole in face place or maybe cutting shoot down alan

We have an older md 8001 changer machine works great until we stated to accept credit crard and people wanted to get a reciept. Reciept doesn't seem to fall down to bottom, you need to stick your finger up slot to grab it. I was wondering if some type of sliding devise would help Maybe some one...

you are great your right i did not take the inner part out i will install to in am the pics are great there is no doubt in my mind this is the greatest site for helping one another alan

so i got it out now can't seemto thread back back on(left handed) i feel like to back to dick and jane in school alan