Search results

thnks Greg, I will check it

Hi, I'll appreciate if somebody can help me. When the two side brushes start to wash the front side of a car, they start spinning about about 30 cm in front of the bonet, so they dont even touch on the face of the car. Side and top washing are ok. I tried to make no load brush test, but on the...

Ok. I will have it in mind

Hi Greg. i dont have a bill vaidator on it.it just work with coins. I already change coin acceptor but nothing happen

Hi The E.W takes the money but does not show them on the display and also does not count them to a wash so the fusion does not start. i have no problem if i use codes everything its ok only with money i have the problem. any idea what the problem is thank you Kyros

Problem solved. Bad float switch Thanks guys.

yes the timer was set to shampoo/vac .today im going to check with my other shampooer

Hi what you mean the lower plug flipped over. please be more specific thank you

Hi Thanks for your reply The product level is ok as i can see it through the clear hose and also as i said it work manually.I also change the timer but nothing happen

Hi guys i have an issue with a vaccum /shampooer. When press the button to select the shampooer the display shows OUT OF ORDER. The machine has a manual key for vaccum and shampooer. When use the key the shampooer works fine.I change the display and val board for microcoin but nothing happen...

Thanks Greg i will have a look

Hi Greg. i m back again.:) i change the wheel proximity works OK for couple of days but now it start the same problem. please help

thanks Greg.i'll have a look on it

Hi ALARM 1 on fusion x. it says "no motion detected gantry motor was on.check for obstuction on gantry track." i drive a car in for washing.the fushion start moving and applying presaok. once it comes at the front of the car it stops.i drive the car out and start again.the second time its ok...

The problem is when the pump first start with any function of high pressure

thanks Paul. I will think about it to send you a ticket:) i also thing that its a matter of air as Greg told me too. so i will start from there and also i will replace the pump head

a lot of vibration and noice on cut pumb.what to do?

hey guys.any one can help:)how to alligne the top brush on fusion x

Not yet but today i solve the problem.there was a keybord socket unplac on the bottom of the board.i just found it by luck

yes its the original one EW2.0.this is the only problem i have the keybord and the program selection buttons