I've had some trouble with my Hamilton Hopper this week. It would overpay and underpay and was showing codes on the Hamilton XE Validator and Controller.
Validator= lower segment of a '1' and a decimal
Controller= '4' pause '3'
After checking various pieces (including the coin counter switch), I traced the problem back to quarters being stuck behind the coin wheel. I fixed and adusted it and it is working fine for the moment.
My questions are...
-What causes quarters to become lodged behind the coin wheel?
-Once it is cleared is it likely to happen again?
-Is this problem more likely to occur with more quarters in the hopper? When I began having trouble there was $700+ in quarters in the hopper, which is more than usual.
Validator= lower segment of a '1' and a decimal
Controller= '4' pause '3'
After checking various pieces (including the coin counter switch), I traced the problem back to quarters being stuck behind the coin wheel. I fixed and adusted it and it is working fine for the moment.
My questions are...
-What causes quarters to become lodged behind the coin wheel?
-Once it is cleared is it likely to happen again?
-Is this problem more likely to occur with more quarters in the hopper? When I began having trouble there was $700+ in quarters in the hopper, which is more than usual.