Modding an "Old" Mark VII Pump Stand
- Thread starter 2Biz
- Start date
It is the PH199-55..... 199K btu modulating and 55 gallon tank...The link below has it the cheapest of anybody online, that I could find. They charged $200 for shipping. It came packaged/crated better than expexted and with no issues...
http://bostonheatingsupply.com/phoenixph199-55.aspx
http://bostonheatingsupply.com/phoenixph199-55.aspx
mjwalsh
6 bay SS w/laundromat
2Biz,
On our CLA Planet laundry forum ... there is a very experienced laundromat operator (Larry Adamski of Muskegon, Michigan) who has been using two Phoenix by HTP for into a few years now & so far they are proving to be an excellent choice as he explains from time to time.
mike walsh http://kingkoin.com/USA_Deficit_Reduction.html
The new Low Pressure System....One Air Regulator for each FB and PS system. Note old position of regulators...Before I needed CV's to keep from back-feeding the regulators when combining/teeing LP air to the bays. New system, regulator is ahead of the solenoids allowing me to eliminate the CV's...
Last edited:
And Finally, (This one is for you IB)....The new FB and PS air shutoff solenoids to eliminate those 1500 gallon ER floods I've had in the past...
***Note the relays I used have a Red Led when activated. A nice feature***
The 1/8" SS Kips are plenty big enough for the air needed for the flojets...
***Note the relays I used have a Red Led when activated. A nice feature***
The 1/8" SS Kips are plenty big enough for the air needed for the flojets...
