Recent content by Noob

I found the coil. https://www.kleen-ritecorp.com/p-23950-cfa-inc-c727-solenoid-valve-coil-24-volt.aspx How do I determine which valve/solenoid I need?

Anybody know where I can a few spares? I understand that CP has gone out of business now. I can’t find anything on kleenrite that looks the same. I’m not even sure what brand these are.

I'm thinking I'll start with tire cleaner, presoak, and maybe hot wax. All are dispensed out of the foam guns. Does this look correct? Do I want SS valve, SS wetted parts? Does end connections mean the products enters and exits out the top and bottom verses the back side?

Im also running tire cleaner out of the foam gun. Would the flow meter needed for that be the same as the presoak?

I don't believe my solenoids are metered. I think they're completely open or completely closed. Instead of changing them out with metered solenoids could do metered flow meters instead and leave the existing solenoids in place?

Missing plug

I had a similar issue. Turned out my vacuum has plastic plugs that cover the concrete anchors inside the bottom of the vacuum. One of my plugs wore out and fell out resulting in complete loss of suction at the hose.

That was part of the original plumbing for the weepmizer. I’ve since disconnected is and added a manual air blow out to all functions. Let me make sure my math is correct. If you’re flowing 10oz per minute that equals .78 gpm? 10/128=.78 So would something like be acceptable...

I may have misspoke. My regulators are before the Flowjets. I have a single regulator for before a flojet that then leads to a bank of solenoids and then out to the bays for each lp function. The corresponding air for that function goes through a regulator then to a bank of solenoids and out to...

How do you determine which flow meter to use? My flojets are g57s rated at 5gpm. I have 4 bays. All of my low pressure lines are 3/8” poly.

2biz, Are you using flojets? If so don’t you have to use a regulator to control the incoming air pressure that pushes the product?

2biz, I’m assuming you only use regulators on the air lines running out to bays and no flow meters? I’m not sure if my solenoids are adjustable? Where did you get the bracket that holds your flow meters?

2biz, Do you use regulators along with flow meters or just flow meters? Currently I have regulator on air and product that controls all 4 bays. I have some discrepancies in product between my bays. I assume I could leave my current set up the same but after the solenoids going out to the bays I...

What kind of problems did you have?

Calling @2Biz Can you give me pointers? I believe you set your wash up this way.